Step 2. On the smaller pieces, measure and lightly mark ½ inch in from the upper corners. Make another mark ½ inch under the highest edges of the items, on heart. Use a straightedge and utility knife to chop between the factors, forming a notch in each pocket. [Fig.
Step 3. With the smooth, or shell, facet of the large piece of leather-based dealing with down, place the smaller pieces shell facet up in order that they're aligned with the outside edges of the larger piece. There must be a 2-inch hole between the items. Use somewhat rubber cement to hold the pockets in place [Fig. B
Step 4. Working across the perimeter of the main piece of leather (even the place the pieces don’t overlap), use an awl to make holes ¼ inch in from the edge and spaced roughly 1/four inch apart [Fig. C
Step 5. Beginning with one of the longer sides of the wallet on high, saddle stitch the leather collectively [Fig. D]. Thread two needles on one piece of thread, one on both end. Start the stitch by passing one needle by way of a nook gap. You must have a needle on either side of the leather at this level. Move one needle via the following gap and to the other aspect, then pass the second needle by way of the same hole in the alternative course. Repeat round your entire walle
Step 6. While you make it again to your first gap, continue stitching one or two holes previous it, overlapping the first pieces of thread. Reduce off any excess thread, then contact the ends with a lighter to melt the ends to the threadin